To increase communications infrastructure, different technologies and installation methods have been developed. One of them is "fiber optic pulling," a method used in underground fiber optic installations where, once the trench is dug and the duct is installed, the fiber is introduced with the help of a series of accessories to pull the fiber along the duct. In this entry, we will learn about some of these accessories.
One of the most important is the pulling guide, also known as a cobra. As its name indicates, it helps us to guide, push, and pull cables. They are made of fiberglass, are resistant, and allow tips to be attached to them to give them more flexibility and prevent kinks. In Figure 1, we can see these accessories.

Another accessory is the cable socks which resemble "finger trap" toys, as the socks "trap" and secure the cable so that it can be pulled without much difficulty. To choose the right one, you need to know the diameter of your cable. Figure 2 shows this "sock."

In addition to these, there are also duct verifiers; these check the circumference of the duct, cleaning brushes, and pulling tapes. An example of these accessories can be found in Figure 3.

Last but not least, there are different designs of one of the simple machines that allows us to have a fulcrum when pulling the fiber: pulleys. These pulleys can be placed at the entrance of the duct, in the manhole, or externally, thus guiding the cable properly. These pulleys can be seen in Figure 4.

Remember that any accessory, tool, or equipment you need can be found at INCOM. Contact us for the advice you need.






